Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
Heidenhain

Hinumerik
Hitachi
Mazak
. . . M Plus
. . . M32 Plus

. . . M32
. . . T32 M2
. . . M2
. . . T2

. . . T Plus
Mitsubishi
Okuma
Sinumerik
Traub
Yasnac

CNC / DNC Settings for Mazak T2

Parameter Value Comments  
 
A15 206

A16 1 = No Parity (But in the DNC software select Even Parity)
A17 6 = Baud rate 4800
A18 6  
A19 0  
A20 1 Use ISO
A21 1  
A22 10  
A23 10  
A24 0 TV Check Off
A30 3  
A31 109  
A32 70  
   

Note: Even though the Mazak is set to 8 Databits No Parity - ensure that the DNC software is set to 7 databits with Even Parity.

RS232 Cable.
9pin computer to 25pin CNC

The simple three wire cable shown above is the most common for this type of control and is compatible with the xOn/xOff (DC1/DC3) flow control suggested on this page.

If you intend using RTS/CTS flow control then an alternative cable shown here is compatible with both xOn/xOff and RTS/CTS.

   

dnc software for acramatic DNC Software for Windows 8, Windows 7, Vista and Windows XP. 32 and 64bit versions
for Acramatic, Fanuc, Okuma, Sinumerik and many other ISO - ASCII CNC Controls.
Single or Multi-Tasking to Communicate with one or more than one control at the same time.
   

MiniMRP is an easy to use Inventory Manager with Multi-Level BOM Manager and other 'MRP'
features usually only available in larger MRP/ERP packages.

Inventory, Single and Multi-Level BOM for less that $200