Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
Heidenhain

Hinumerik
Hitachi
Mazak
. . . M Plus
. . . M32 Plus

. . . M32
. . . T32 M2
. . . M2
. . . T2

. . . T Plus
Mitsubishi
Okuma
Sinumerik
Traub
Yasnac

CNC / DNC Settings for Mazak M Plus / T Plus

Parameter Value Comments  
User Parameter #5
G1 1 = Baud Rate 9600
G2 3 = 2 Stop Bits
G3 0 = Even Parity
G5 3 = 8 Data Bits (Set DNC to software to 7 Databits)
G6 1  
G10 3 Use xOn/xOff flow control (DC1 and DC3)
G12 0 Do not use DC2 and DC4)
G13 50  
G17 00000000  
G31 00000000  
G33 50  
G34 10  
G39 00000100  
G40 00000000  
G48 0  
   

Note: Even though the Mazak is set to 8 Databits - ensure than the DNC software is set to 7 databits.

   

In the DNC software select xOn/xOff flow control

RS232 Cable.
9pin computer to 25pin CNC

The simple three wire cable shown above is the most common for this type of control and is compatible with the xOn/xOff (DC1/DC3) flow control suggested on this page.

If you intend using RTS/CTS flow control then an alternative cable shown here is compatible with both xOn/xOff and RTS/CTS.

   

dnc software for acramatic DNC Software for Windows 8, Windows 7, Vista and Windows XP. 32 and 64bit versions
for Acramatic, Fanuc, Okuma, Sinumerik and many other ISO - ASCII CNC Controls.
Single or Multi-Tasking to Communicate with one or more than one control at the same time.
   

MiniMRP is an easy to use Inventory Manager with Multi-Level BOM Manager and other 'MRP'
features usually only available in larger MRP/ERP packages.

Inventory, Single and Multi-Level BOM for less that $200