Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
Heidenhain

. . . Blockwise

. . . TNC 155
. . . TNC 355
. . . TNC 360

. . . TNC 370
. . . TNC 415
. . . TNC 425
. . . TNC 2500
Hinumerik
Hitachi
Mazak
Mitsubishi
Okuma
Sinumerik
Traub
Yasnac

CNC / DNC Settings for Heidenhain TNC335

Parameter Value Comments  
 
Baud Rate
TNC External Interface is capable of speeds between 110 and 38400. For non-blockwise transfers in to CNC memory we would suggest using 4800 or lower. But if you need to drip feed large complex programs then a higher speed will almost certainly be required and you should enable the Blockwise Protocol mentioned below.
Device
EXT
RS232 Interface
5010.0
515
5010.1
17736
5010.2
16712
5010.3
279
5010.4
5382
5010.5
4
5020
104
7bits. Even parity. 2 Stop Bits. use DC3 (xOnXoff)
5030
1

Blockwise Protocol Enabled (0 = Disabled)

   


The Heidenhain TNC 335 can be configured to use the Heidenhain Blockwise Protocol for high speed reliable drip feeding of programs that exceed the memory capacity of the machine. Blockwise Protocol is Enabled/Disabled via parameter 5030.

Use a DNC program capable of communicating using Heidenhain Blockwise.
See this page for setting up RemoDNC to drip feed large programs using Heidenhain Blockwise Protocol

 

RS232 Cable.
9pin computer to 25pin CNC

 

   

dnc software for acramatic DNC Software for Windows 8, Windows 7, Vista and Windows XP. 32 and 64bit versions
for Acramatic, Fanuc, Okuma, Sinumerik and many other ISO - ASCII CNC Controls.
Single or Multi-Tasking to Communicate with one or more than one control at the same time.
   

MiniMRP is an easy to use Inventory Manager with Multi-Level BOM Manager and other 'MRP'
features usually only available in larger MRP/ERP packages.

Inventory, Single and Multi-Level BOM for less that $200