Acramatic
Amada
Anilam
Bosch
Boss
DeltaDynaPath
Fagor
Fanuc
. . . Fanuc Oi
. . . Fanuc OM
. . . Fanuc OP
. . . Fanuc OT
. . . Fanuc 6
. . . Fanuc 10
. . . Fanuc 11
. . . Fanuc 12
. . . Fanuc 15
. . . Fanuc 16
. . . Fanuc 18
. . . Fanuc 21i
. . . Fanuc 21
Heidenhain
Hinumerik
Hitachi
Mazak
Mitsubishi
Okuma
Sinumerik
Traub
Yasnac

CNC / DNC Settings for Fanuc OM

Parameter Value Comments  
 
0002 00000001  
0552 9 Baud rate - see table below for valid options.
  6 = 300
7 = 600
8 = 1200
9 = 2400 * (recommended)
10 = 4800
11 = 9600
 
TV On/Off 0 0 = TV Check OFF (1= TV Check ON - Never enable TV Check)
ISO 1 1 = ISO (0=EIA Never use EIA)
I/O 0  
     
Drip Feed ?

To drip feed enable para G127.5
Select Auto (DNC) mode on the control - Press Cycle Start.
Then go to the computer, prepare the program and click 'Send'. When data begins to flow the machine will start moving.

RS232 Cable.
9pin computer to 25pin CNC

Cable shown here works with xOn/xOff (DC1/DC3) flow control and RTS/CTS (Hardware flow control so should work in most cases.

But if you're sure your CNC does not use any flow control - or requires only xOn/xOff then you may use the the simpler 3 wire cable. Diagram here.

   

dnc software for acramatic DNC Software for Windows 8, Windows 7, Vista and Windows XP. 32 and 64bit versions
for Acramatic, Fanuc, Okuma, Sinumerik and many other ISO - ASCII CNC Controls.
Single or Multi-Tasking to Communicate with one or more than one control at the same time.
   

MiniMRP is an easy to use Inventory Manager with Multi-Level BOM Manager and other 'MRP'
features usually only available in larger MRP/ERP packages.

Inventory, Single and Multi-Level BOM for less that $200